It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
Why does my garage door track to one side.
I had a garage door company here that told me my garage door needs to be balanced and showed me how it would not stay up by itself when door is not engaged.
Changed them to be the same and now the cables are equal and the track isn t hitting the door.
Or it could just be that the hardware has become loose over time.
By pushing the door back into position you should have made the vertical track straighten.
If you ve had your door for a while or are in and out of it a lot it can easily end up out of alignment.
Maybe someone bumped into it recently.
Most track damage happens to the vertical tracks that attach to the wall of the garage door opening.
The cable is attached to the door and runs to an s hook that attaches to the track support.
Yeah that was it.
Garage door shifts to one side.
The vertical tracks should be in a slight v instead of being plumb up down.
I have no overhead garage door one third horsepower.
With misaligned tracks the risk of the rollers coming off the tracks gets much higher.
This usually happens when the bolts holding the horizontal tracks get loose causing the bracket to wobble at the slightest unnatural vibrations of the door.
Push the door back to adjust the door and get the center aligned again.
The span from rail to rail is about 1 2 3 4 off but i guess that should be okay.
Click on a problem below to see the possible causes and solutions.
Move the bottom of the track on the right closer to the door so it can t shift back.
The track should be tighter at the bottom then at the top if it is tight enough at the bottom the door will always close in the same position.
Misaligned tracks misaligned tracks are another common cause for a garage door going off track.
Your door has simply shifted to one side.
Bottom of the door is up on one side.
The front measured 15 and the back measured 16 from the wall.
The door runs are housed in a garage door track one on each side of the garage door.
With the door propped open take the s hook out of the support and tighten or loosen the cable as needed.
Bent tracks on your garage door need immediate repair to get the door working properly.